Energy IP Gateway Unit RT-EG-IP — Technical Datasheet
Last updated 5 August 2026 · Published 5 August 2026
Energy Gateway Unit is an Ethernet based solution which takes the Energy and Power related
parameters to Remote Server and also executes commands to drive the outputs and
configurations. Energy Gateway Unit has inbuilt 2 opto-isolated input Zones,2 RTD
Temperature/Lux zones, UPS battery voltage measurements and two relay controlled output
Zones. The output can be operated remotely or through any of the pre-set schedules. The 2
RTD Zones shall be configured as temperature or Lux Zone by using the configurators. Also the
device can measure UPS DC voltage upto 140V DC. The product features are expandable by
using the MODBUS RTU—RS485 Port and UART Port through which user can interface IRC, DG
Monitoring, UPS Monitoring and Energy monitoring The product comes with a Software Tool to
Configure, Control, Schedule and to Report.
Note: I- IRC interface, E1- for 1 Energy Meter, E2- for 2 Energy Meter, E3- for 3 Energy Meter, E4- for 4 Energy
Meter, D- DG monitoring, U- UPS interface,
Features
- An Ethernet-based device for indoor use
- 2 Analog zones, which can be configured and used as temperature or Lux zones
- 2 configurable Digital Zones
- 2 outputs are controllable from remote manually and through 4 different schedules
- Isolated UPS battery voltage measurement up to 140VDC
- Provision to interface RS485 modbus – Raxtech IRC-5 relays 2x30A, 3x8A relays with
- circuit ON/OFF status.
- Provision to interface PROTECH DG monitoring – DG fuel level, Battery voltage
- through Modbus/RS485
- Provision to interface RS485 Modbus – 3-phase energy meter up to 4 no’s.
- Provision to interface UPS through RS232 Port.
- Software utility to configure, monitor, control, and report.
- Power Consumption - 12VDC, 2A
This page covers the specification content of the datasheet. The PDF also contains product selections, dimensions, calibration, certification, warranty and revision history — download it for those.